THE USE OF OIL PALM FIBER AS AN ADDITIVE IN CONCRETE


THE USE OF OIL PALM FIBER AS AN ADDITIVE IN CONCRETE

ABSTRACT 

This study on strength development of concrete quality and properties using oil palm fiber was carried out to enhance and improve the quality and properties of concrete by using additive. Additive is substances added to fresh concrete to typically improve its properties. The research was conducted to establish the effect of oil palm fiber addition on workability, density and compressive strength of concrete. The mixes were prepared with fiber cement ratio of 0%, 0.25%, 0.50% and 1.0% respectively. A total of 16 concrete cubes. Specimens of 150mm X 150mm X 150mm were prepared for compressive strength testing after been cured in water for 7 days and 28 days. Workability of the concrete decreased with the increase in fiber content added to the mix. The result of density test shows that the highest density of 2.97g/cm3 was achieved when 0.25% fiber was added. Test results of compressive strength on concrete also demonstrated that of 19.6 N/mm2   and 25.65 N/mm2 addition of 0.25% fiber content to concrete gave the highest compressive strength. The compressive strengths with the addition of 0.25% fiber content gave higher values than the control mixes of both 7 days and 28 days. It is therefore recommended that 0.25% fiber can be added to concrete mix.   

TABLE OF CONTENT

Title page 

Certification 

Dedication 

Acknowledgement 

Abstract 

Table of content 

CHAPTER ONE 

INTRODUCTION 

1.0 General  

1.1 Historical background of the use of oil palm fiber as an additive in concrete 

1.2 Problem statement  

1.3 Objectives of the study 

1.4 Scope of the research 

CHAPTER TWO 

LITERATURE REVIEW 

2.1 Introduction 

2.2 Classification of fibers 

2.3 Stiff and strong fibers 

2.4 Synthetic fibers 

2.4.1 Metallic fibers 

2.4.2 Polymeric fiber 

2.4.2.1 Acrylic fiber 

2.4.2.2 Aramid fibers 

2.4.2.3 Nylon 

2.4.3 Carbon fiber 

2.4.4 Glass fiber 

2.5 Naturally occurring fiber 

2.5.1 Bambo fiber 

2.5.2 Coconut fiber 

2.5.3 Wood fiber 

2.6 Palm fiber 

2.7 Compressive strength 

CHAPTER THREE 

RESEARCH METHODOLOGY 

3.1 Introduction 

3.2 Programme of experiment 

3.3 Instrumentation and laboratory works 

3.4 Raw materials 

3.4.1 Cement 

3.4.1.2 Water  

3.4.1.3 Coarse aggregate 

3.4.1.4 Fine aggregate 

3.4.1.5 Oil palm fiber 

3.5 Mixing process 

3.6 Method of curing 

3.7 Test on concrete 

3.7.1 Slump test 

3.7.2 Compressive strength test 

3.7.3 Density test 

CHAPTER FOUR 

RESECTS AND DISCUSSION 

4.1 Introduction 

4.2 Test on fresh concrete 

4.2.1 Results of slump test (workability) 

4.3 Test on hardened concrete 

4.3. 2 Results of compressive strength test of concrete 

CHAPTER FIVE 

CONCLUSION AND RECOMMENDATION 

5.1 Conclusion 

5.2 Recommendation                 

References

           Appendix            

CHAPTER ONE

INTRODUCTION

1.0 GENERAL

Concrete is a composite material that consists essentially of a binding medium within which are embedded particles of fragments of aggregate (ASTMC 125). In hydraulic cement concrete, the binder is formed from a mixture of hydraulic cement and water. Concrete is a universal material used mostly in construction work.

In his 1961 presidential address to the ACI convention, calling concrete a universal material and emphasizing that all engineers need to know more about concrete, J.W. Kelly said:

One would not think of using wood

for a dam, steel for pavement, or asphalt

for a building frame, but concrete is used

for each of these and for many other

uses than other construction materials.

Even where another material is the principal

component of a structure, concrete is usually used

with it for certain portions of the work.

It is used to support, to enclose, to surface, and to fill.

           In order to improve some of the properties of concrete in both the fresh and hardened states, certain chemical products are added to the mix. These chemical are called admixtures (Mehta and Monterio, 2001).

         As years and time went by, other materials which are in-organic in nature were also introduced into the mix of concrete. The original reasons for using the in-organic materials were usually for economic purposes due to the fact that they are cheaper and they exist as natural deposit or wastes. They require little or no processing, such in-organic materials are called additives.

More so, the use of some additive materials was provided by ecological concerns about opening of oil palm industries for the additive material (oil palm fiber) required for the use of a concrete and on the other hand, the means of disposing the industrial waste such as coconut fiber, sugar cane fiber etc. virtually all the materials bestowed various desirable properties on concrete, sometimes the fresh state but more often in the hardened state. Therefore because of this fact and virtue in many countries, high proportion of concrete contain one or more of these additive materials as added and used as an additive in concrete.

1.1 HISTORICAL BACKGROUND OF THE USE OF OIL PALM FIBER AS AN ADDITIVE IN CONCRETE

The African Oil palm, with botanical name Elaeis guineenis is native to tropical Africa, from Sierra Leone in the West through the Democratic Republic of Congo in the East. It was domesticated in its native range, probably in Nigeria, and moved throughout tropical Africa by humans who practiced shifting agriculture at least 5000 years ago. European explorers discovered the palm in the late 1400’s and distributed it throughout the world during slave trade period. In the early 1800’s the slave trade ended but British began trading with West Africans in Ivory, lumber and palm oil. The oil palm was introduced to the Americas hundreds of years ago, where it became naturalized and associated with slave plantations, but did not become an industry of its own until the 1960s. The first plantations were established on Sumatra in 1911, and in 1917 in Malaysia.

Oil palm fiber originated from the empty fruit bunch i.e one of the oil palm residues. Oil palm residues contained huge amount of lignocelluloses materials such as empty fruit bunches, oil palm fronts and trunks that help to strengthen the bonding of structure of building materials. These residues are assets for the country to turn its abundant supply of oil palm industrial by-products into value-added products. This results in optimizing the usage of these residues and completely scraping the idea of burning the residues that often create environmental problems by generating severe air pollution that is against the Environmental Protection Act.

Palm oil fibers which the palm oil fruit bunches produced are clean, biodegradable and can be compared to many other residues originating from other agricultural plantation. Generally, the oil palm fruit bunches are used as composite in manufacturing of mattress, car seat, insulator, composite panel product and particle board. The oil palm fibers have much ability that improves certain properties that combines with it, hence it is suitable for cement based building products.

Studies have been carried out to investigate oil palm fiber as an additive in concrete. It has been reported that the strength of concrete increased by more than 40% of its original strength when the fiber is added into the concrete. The percentage used was 0.10% and 0.25% fibers by weight of cement. Studies have shown that the increase in strength is due to that hemicelluloses, cellulose and lignin, further investigation has also been carried out to investigate the use of oil palm fiber as an additive in concrete. In which report as shown that the oil palm fibers increase the compressive strength of the concrete.

1.2 PROBLEM STATEMENT

Over hundred years, the oil palm industries found themselves faced with so many problems of vital importance arising from the oil crises of 1973. The cost of burning the residues obtained from oil palm industries most especially the oil palm fibers and some other residues that often create environmental problems by generating severe air pollution which is against the Environmental Protection Act. It was also discovered that the fibrous biomass is yet to be commercially exploited. This prompts the technology development in the industry to still focus on process development and improvement rather than creating and inventing newer products for value-added application. The need for materials not harmful to the body but having appropriate properties which has increased due to  lack of resources and increase in environmental pollution.

So, the fact that oil palm fiber can be added to other constituent materials of concrete to be used as an additive, this project was simply carried out to determine the increase in strength of concrete. This creates another alternative for uses rather than burning the fibers which cause environmental problem and generate air pollution.

Therefore, this project will be justified if the experiment succeeds. In establishing the fact that oil palm fiber can be used as an additive in concrete without losing most of its structural properties rather increase the properties most especially the strength of the concrete and thus creates more benefits that make the structures to be more durable.

1.3 OBJECTIVES OF THE STUDY

The main aim of this study was to find out the possibility of using oil palm fiber as an additive in concrete and improving the properties of concrete. The objectives are listed below;

1. To study the strength of oil palm fiber concrete (OPFC)

2. To gain knowledge about naturally reinforced concrete

3. To find out the advantages of oil palm fiber added concrete as compared to conventional concrete.

1.4 SCOPE OF THE RESEARCH

The scope of this research is limited by finance and time as it is generally known that concrete is a very complex constructional material whose strength can be affected by many factors ranging from the quality of the constituent materials, quality of the concrete mix and ambient temperature. The effect of all these factors should be considered.

Therefore, the title and short period of time is not just enough to maintain all these confirmations.

More so, the facts that concrete are destructive in nature implies that there is little or no allowance for repeated material utility. So any extension of the research to cover those aspect earlier mentioned will require more materials and more financial power involvement.

So, the research project work is limited to the comparation of the compressive strength test, slump test and density test of the ordinary mixed concrete only and the additive concrete (i.ess when oil palm fiber is added).

.

THE USE OF OIL PALM FIBER AS AN ADDITIVE IN CONCRETE



TYPE IN YOUR TOPIC AND CLICK SEARCH.






RESEARCHWAP.ORG

Researchwap.org is an online repository for free project topics and research materials, articles and custom writing of research works. We’re an online resource centre that provides a vast database for students to access numerous research project topics and materials. Researchwap.org guides and assist Postgraduate, Undergraduate and Final Year Students with well researched and quality project topics, topic ideas, research guides and project materials. We’re reliable and trustworthy, and we really understand what is called “time factor”, that is why we’ve simplified the process so that students can get their research projects ready on time. Our platform provides more educational services, such as hiring a writer, research analysis, and software for computer science research and we also seriously adhere to a timely delivery.

TESTIMONIES FROM OUR CLIENTS


Please feel free to carefully review some written and captured responses from our satisfied clients.

  • "Exceptionally outstanding. Highly recommend for all who wish to have effective and excellent project defence. Easily Accessable, Affordable, Effective and effective."

    Debby Henry George, Massachusetts Institute of Technology (MIT), Cambridge, USA.
  • "I saw this website on facebook page and I did not even bother since I was in a hurry to complete my project. But I am totally amazed that when I visited the website and saw the topic I was looking for and I decided to give a try and now I have received it within an hour after ordering the material. Am grateful guys!"

    Hilary Yusuf, United States International University Africa, Nairobi, Kenya.
  • "Researchwap.org is a website I recommend to all student and researchers within and outside the country. The web owners are doing great job and I appreciate them for that. Once again, thank you very much "researchwap.org" and God bless you and your business! ."

    Debby Henry George, Massachusetts Institute of Technology (MIT), Cambridge, USA.
  • "Great User Experience, Nice flows and Superb functionalities.The app is indeed a great tech innovation for greasing the wheels of final year, research and other pedagogical related project works. A trial would definitely convince you."

    Lamilare Valentine, Kwame Nkrumah University, Kumasi, Ghana.
  • "I love what you guys are doing, your material guided me well through my research. Thank you for helping me achieve academic success."

    Sampson, University of Nigeria, Nsukka.
  • "researchwap.com is God-sent! I got good grades in my seminar and project with the help of your service, thank you soooooo much."

    Cynthia, Akwa Ibom State University .
  • "Sorry, it was in my spam folder all along, I should have looked it up properly first. Please keep up the good work, your team is quite commited. Am grateful...I will certainly refer my friends too."

    Elizabeth, Obafemi Awolowo University
  • "Am happy the defense went well, thanks to your articles. I may not be able to express how grateful I am for all your assistance, but on my honour, I owe you guys a good number of referrals. Thank you once again."

    Ali Olanrewaju, Lagos State University.
  • "My Dear Researchwap, initially I never believed one can actually do honest business transactions with Nigerians online until i stumbled into your website. You have broken a new legacy of record as far as am concerned. Keep up the good work!"

    Willie Ekereobong, University of Port Harcourt.
  • "WOW, SO IT'S TRUE??!! I can't believe I got this quality work for just 3k...I thought it was scam ooo. I wouldn't mind if it goes for over 5k, its worth it. Thank you!"

    Theressa, Igbinedion University.
  • "I did not see my project topic on your website so I decided to call your customer care number, the attention I got was epic! I got help from the beginning to the end of my project in just 3 days, they even taught me how to defend my project and I got a 'B' at the end. Thank you so much researchwap.com, infact, I owe my graduating well today to you guys...."

    Joseph, Abia state Polytechnic.
  • "My friend told me about ResearchWap website, I doubted her until I saw her receive her full project in less than 15 miniutes, I tried mine too and got it same, right now, am telling everyone in my school about researchwap.com, no one has to suffer any more writing their project. Thank you for making life easy for me and my fellow students... Keep up the good work"

    Christiana, Landmark University .
  • "I wish I knew you guys when I wrote my first degree project, it took so much time and effort then. Now, with just a click of a button, I got my complete project in less than 15 minutes. You guys are too amazing!."

    Musa, Federal University of Technology Minna
  • "I was scared at first when I saw your website but I decided to risk my last 3k and surprisingly I got my complete project in my email box instantly. This is so nice!!!."

    Ali Obafemi, Ibrahim Badamasi Babangida University, Niger State.
  • To contribute to our success story, send us a feedback or please kindly call 2348037664978.
    Then your comment and contact will be published here also with your consent.

    Thank you for choosing researchwap.com.