PRODUCE CLEAN GRAIN FROM MULTI CROP THRESHER FOR SMALL SCALE FARMERS


PRODUCE CLEAN GRAIN FROM MULTI CROP THRESHER FOR SMALL SCALE FARMERS  

ABSTRACT

The traditional methods of threshing of crops are inefficient, laborious, and time consuming and low out put. The existing fabricated machine was observed during preliminary testing to have low performance. In the light of the above mentioned problems, there is need to modify and testing multi-crop thresher to threshed grain at optimum speed. The threshing machine consist of the following component: Hopper, frame, beater, sieve, pulley, grain outlet and chaff outlet. The factors considered in this project work was feed rate at two levels of 2 level and were replicated twice (f1=2kg, f2=3kg) at a constant speed of 300rpm. The parameters under investigation were threshing efficiency, unthreshed efficiency, and breakage efficiency. The result revealed that themachine has a threshing efficiency, untrhreshed efficiency, and breakage efficiency of 90.1%, 9.5%, and 20.1% for feed rate 2kg and 90.9%, 9.1% and 14.11% for feed rate 3kg respectively. The time taken for 2kg and 3kg was 50.2sec and 43sec, the throughput capacity for 2kg was 143kg|hr and 3kg was 167kg|hr respectively. The feed rate of 3kg favors the machine performance.

TABLE OF CONTENTS 

Title page i

Certification ii

Dedication iii

Acknowledgement iv

Abstract v

Table of contents vi-ix

List of figures x

List of plates xi

List of tables’ xii

CHAPTER ONE: INTRODUCTION

1.1Background of the study1

1.2Problem statement 2

1.3 Aims and objectives 3

1.4 Justification 3

1.5 Scope of the project 4

CHAPTER TWO: LITERATURE REVIEW

2.1Threshing Process5

2.2 Agronomy of selected crops 6

2.2.1Maize crop6

2.2.3 Guinea corn 6

2.3 Post Harvest loss on grain 7

2.4 Factors Affecting Threshing 7

2.5 Methods of Threshing 8

2.5.1 Local Methods of Threshing 8

2.5.1.1 Manual Method of grain 8

2.5.1.2 Threshing with animal or vehicle 9

2.5.1.3 Threshing with hand driven machine 9

2.5.2 Modern method of threshing 9

2.5.2.1 Em-bee power thresher 10

2.5.2.2 Midget thresher 10

2.5.2.3 FGN pedal operated thresher 11

2.5.2.4 NCAM Multi-crop thresher 11

2.6 Review on exiting work on threshing machine 11

CHAPTER THREE: MATERIALS AND METHODS

3.1 Modified Areas 14

3.2 Description of the multi-crop thresher 14

3.3 Design consideration 18

3.4 Design Analysis and calculation 18

3.4.1 Design hopper 18

3.4.2 Design for power requirement 19

3.4.3 Design for shaft 21

3.4.4 Pulley design 23

3.4.5 Belt design 24

3.4.6 Design for motor seat 24

3.4.7 Bearing selection 25

3.5 Materials selection 26

3.6 Fabrication procedure and assembly 26

3.6.1 Hopper 26

3.6.2 Frame 27

3.6.3 Threshing unit 27

3.6.4 Driven unit 27

3.6.5 Winnowing unit 27

3.6.6 Grain outlet 28

3.6.7 Shaft outlet 28

3.7 Principle of operation 28

3.8 Test Performance 28

3.8.1 Source of materials 28

3.8.2 Sample preparation 29

3.8.3 Experimental procedure 29

3.8.4 Output parameter 29

3.8.4.1 Threshing efficiency 29

3.8.4.2 Unthreshed efficiency 29

3.8.4.3 Throughput capacity 29

3.8.4.4 Determination of threshing throughput capacity 30

CHAPTER FOUR: RESULT AND DISCUSSION

4.1 Result 31

4.2 Discussion 32

CHAPTER FIVE: CONCLUSION AND RECOMMENDATION 

5.1 Conclusion 33

5.2 Recommendation 34

References 35

Appendices

CHAPTER ONE

INTRODUCTION

1.1 Background of the Study

Cowpea is a grain legumes appears to have originated from west-African, very widely in Nigeria were there are many wild weedy species in both savanna and forest zone (Steel, 1992).Cowpeas are now widely distributed throughout the tropics and sub-tropics. They are grown in India, south eastern Asia, and Australia the Caribbean, southern united state and throughout the low land tropical Africa. Nigeria alone produces 61% (760000 tones) of the world total production (Irtwange 2009). Despite this figures, Nigeria continues to suffer from hunger and malnutrition. This is because the rate that of population growth is exceeded the rate of food production with a consequent decline in per capital food intake (Irtwange 2009). This call for the need to step up food production.

Grain, according to Okaka (2004) is fruit of cultivated grasses belonging to the family of monocotyledonous, gramineace. The principle cereal grain of the world includes wheat, beans, sorghum, rice and maize. Agriculture commodities are consumed as food and grains contributed to the bulk of the country’s calories and protein. The world grain is broadly used to indicate cereals and pulses. Grain however can be grown extensively for food and the fast growing agricultural based industries. They are used in either fresh form or dried form.  Dried grains are preferred for industrial uses. The major processing methods used in preparing grain are dry milling wet milling and malting (Olatunji,2000).

Maize (zeamays) is cereal crops that are grown widely throughout the world in a range of agro ecological environments more maize is produced annually than any other grains. About 50 species exist and consist of different colors, texture and grain shapes and seize, white yellow and red are most common types. The white and yellow varieties are preferred by most people depending on the region maize was introduced into Africa the 1500s and since become one of African dominant food crop. The grains are rich in vitamin A, C, and E carbohydrates and essential minerals and contain 99% protein. They are also rich in dietary fiber and calories which are good source of energy (Adeokoma2001).

The major steps involves in the processing of maizeare harvesting, drying, de-husking, shelling, storage and milling. For rural framers to maximize profit from the maize, appropriate technology that suites thresher needmust be used. The processing of the agricultural product like maize into quality form not only prolong thesheff life of these product but also increase the net profit the farmer make from mechanization technology of such product.(okaka 2004). Guinea corn (sorghum) is a cereal grain that originated in Africa and is eaten throughout the world. It is especially valuable in arid terrain because of its resistance to drought, guinea corn is a nutrient rich grain that is often grand into flour to make bread, porridge and pancake including it diet offers a number of nutritional and the rapeutic benefit guinea corn contain 163calories protein, carbohydrate, fat content minerals, the one nutritional highlight of guinea corn is its mineral content. Adequate intake of iron support the transportation of oxygen in the body system and helps to promote cell growth and development of potassium helps to maintain fluid balance, and high intake in food blood pressure according to American heart association (Purseglove, 2007).

1.2 Problem Statement

Traditional threshing method do not support large- scale threshing of grains especially for commercial purposes. Locally in Nigeria the region that is the highest producer of grain like maize is the northern part of the country it was observed that the most threshing of grainwasdone by hand shelling. Hand threshing take a lot of time, even with some hand operated simple tools, it was also observed in the study area, most mechanical threshers were designed for multi grain threshing or shelling, which causes great damage to the grain seed besides breaking the maize cob to pieces the available Shellerwere locally equipped with rotating threshing drum with beater or teeth which cause damages to the seed. Besides, the costs of purchasing such thresher were high for poor rural farmer and therefore necessitated the design of low cost system that will be affordable and also increases threshing efficiency but reduce damage done to the seed (Ogunwede,2003).

1.3 Aims and objectives of the Study

The main aim of this project is to produce clean grain from multi crop thresher for small scale farmers. The specific objectives are to:

i. Design the sieve, blower and electric motor seat.

ii. To evaluate the machine in term of threshing efficiency, unthreshed efficiency, breakage efficiency and through put capacity of the machine.

1.4 Justification of the Study

The modification and performance evaluation of this project will reduce the quantity of crops blowing out of the outlet, will enhance good quality product, will reduce or eliminate drudgery compare to traditional methods of threshing and also large quantity of grain will be threshed within a very short time.

1.5The Scope of the Project

Cereals are widely cultivated in Nigeria;this study is limited to the threshing ofmaize. . Maize otherwise known as corn is important to the economy due to its wide range of users. Maize is primarily used as feed for livestock, suggesting the dependence of livestock industry or corn product.Its also used to create a variety of food and non food product such as corn meals, sweetener, corn oil, starch and ethanol which is used as cleaner burning alternative to gasoline. Factors consider was feed rate at two levels and speed at one level and were replicated twice. The parameters under investigation were threshing efficiency, unthreshed efficiency and breakage efficiency. 

.

PRODUCE CLEAN GRAIN FROM MULTI CROP THRESHER FOR SMALL SCALE FARMERS



TYPE IN YOUR TOPIC AND CLICK SEARCH.






RESEARCHWAP.ORG

Researchwap.org is an online repository for free project topics and research materials, articles and custom writing of research works. We’re an online resource centre that provides a vast database for students to access numerous research project topics and materials. Researchwap.org guides and assist Postgraduate, Undergraduate and Final Year Students with well researched and quality project topics, topic ideas, research guides and project materials. We’re reliable and trustworthy, and we really understand what is called “time factor”, that is why we’ve simplified the process so that students can get their research projects ready on time. Our platform provides more educational services, such as hiring a writer, research analysis, and software for computer science research and we also seriously adhere to a timely delivery.

TESTIMONIES FROM OUR CLIENTS


Please feel free to carefully review some written and captured responses from our satisfied clients.

  • "Exceptionally outstanding. Highly recommend for all who wish to have effective and excellent project defence. Easily Accessable, Affordable, Effective and effective."

    Debby Henry George, Massachusetts Institute of Technology (MIT), Cambridge, USA.
  • "I saw this website on facebook page and I did not even bother since I was in a hurry to complete my project. But I am totally amazed that when I visited the website and saw the topic I was looking for and I decided to give a try and now I have received it within an hour after ordering the material. Am grateful guys!"

    Hilary Yusuf, United States International University Africa, Nairobi, Kenya.
  • "Researchwap.org is a website I recommend to all student and researchers within and outside the country. The web owners are doing great job and I appreciate them for that. Once again, thank you very much "researchwap.org" and God bless you and your business! ."

    Debby Henry George, Massachusetts Institute of Technology (MIT), Cambridge, USA.
  • "Great User Experience, Nice flows and Superb functionalities.The app is indeed a great tech innovation for greasing the wheels of final year, research and other pedagogical related project works. A trial would definitely convince you."

    Lamilare Valentine, Kwame Nkrumah University, Kumasi, Ghana.
  • "I love what you guys are doing, your material guided me well through my research. Thank you for helping me achieve academic success."

    Sampson, University of Nigeria, Nsukka.
  • "researchwap.com is God-sent! I got good grades in my seminar and project with the help of your service, thank you soooooo much."

    Cynthia, Akwa Ibom State University .
  • "Sorry, it was in my spam folder all along, I should have looked it up properly first. Please keep up the good work, your team is quite commited. Am grateful...I will certainly refer my friends too."

    Elizabeth, Obafemi Awolowo University
  • "Am happy the defense went well, thanks to your articles. I may not be able to express how grateful I am for all your assistance, but on my honour, I owe you guys a good number of referrals. Thank you once again."

    Ali Olanrewaju, Lagos State University.
  • "My Dear Researchwap, initially I never believed one can actually do honest business transactions with Nigerians online until i stumbled into your website. You have broken a new legacy of record as far as am concerned. Keep up the good work!"

    Willie Ekereobong, University of Port Harcourt.
  • "WOW, SO IT'S TRUE??!! I can't believe I got this quality work for just 3k...I thought it was scam ooo. I wouldn't mind if it goes for over 5k, its worth it. Thank you!"

    Theressa, Igbinedion University.
  • "I did not see my project topic on your website so I decided to call your customer care number, the attention I got was epic! I got help from the beginning to the end of my project in just 3 days, they even taught me how to defend my project and I got a 'B' at the end. Thank you so much researchwap.com, infact, I owe my graduating well today to you guys...."

    Joseph, Abia state Polytechnic.
  • "My friend told me about ResearchWap website, I doubted her until I saw her receive her full project in less than 15 miniutes, I tried mine too and got it same, right now, am telling everyone in my school about researchwap.com, no one has to suffer any more writing their project. Thank you for making life easy for me and my fellow students... Keep up the good work"

    Christiana, Landmark University .
  • "I wish I knew you guys when I wrote my first degree project, it took so much time and effort then. Now, with just a click of a button, I got my complete project in less than 15 minutes. You guys are too amazing!."

    Musa, Federal University of Technology Minna
  • "I was scared at first when I saw your website but I decided to risk my last 3k and surprisingly I got my complete project in my email box instantly. This is so nice!!!."

    Ali Obafemi, Ibrahim Badamasi Babangida University, Niger State.
  • To contribute to our success story, send us a feedback or please kindly call 2348037664978.
    Then your comment and contact will be published here also with your consent.

    Thank you for choosing researchwap.com.